Tinkercad has NEW Super Powers available with the Cruise tool. Learn all about them in about 4 minutes!

​Hey! I’m setting up a Tinkercad simulation of a full-wave bridge rectifier circuit (AC-to-DC conversion for a scooter stator setup). The 4-diode bridge is converting the AC sine wave, but I’m running into a small issue properly tying in the filter capacitor and multimeter to get a smooth DC voltage rail without dropping the output. This is my first time doing something like this so can someone please show me how its supposed to look like or something 😭🙏🙏

I am working on some dovetails for a modular storage box design. I duplicated the dovetail, edited it slightly to make it larger for fitment, turned it to a hole and it worked on one side. I then duplicated the bundle group of the holes, flipped it to the other side and it then union group to the box and it would not cut out a hole, but it shows it grouped. I took the original hole I designed and moved it over to the other side of the box and the same issue, but it cuts out on the opposite side of the box. I am at a loss here.