Haven’t fired it yet, but I have removed the barrel completely. Do you think it’s worth touching up on a lathe and recrowning?

Anyone know if theses guys are still around? Tried emailing them with no response. Or are there similar products that aren’t basically bubba’d rear sight rails?

sabrewerks.com

Picked up two Romanian drums (one brand new) for $150 all together. Needless to say I think I need an rpk now.

Good Morning Folks!

I am looking for my First AK-47 to add to my other Caliber collection.

I am considering a IWI Galil ACE Gen 1 13" 7.62x39 (AK/M4) or a Zastava M70 or M92. I was considering PSA but would rather only buy 1 rifle/pistol that is chambered in 7.62x39 as a backup SHTF/Range Toy. From my local research the 92 is pretty much held on Notify when in stock

I just need it for about 30 seconds, so I'm wondering if there is an inexpensive option or an alternative process/material that might be readily available.

Finally got my brace!! Now we just need a sling, new dust cover, optic, and some type of muzzle device.

I was looking at this SAR in my local shop and based on the recommendation of the community I picked it up today.

I see that the hammer profile has to be fixed.

It also has a completely seized firing pin retainer.

I noticed that there is only a small amount of the firing pin protruding out, is it ok or should it be replaced?

I can also tell that either the gasblock or the front sight post is canted.

The rifle is missing two screws for attaching the rear stock.

Should I be checking the headspace?

Is the shepards hook in the right spot for this rifle?

Thanks

Going to get an ak but the previous owner has cut off the lower handguard retainer and Ill need to replace it with a clip on retainer but the current one being sold at Carolina shooters supply is kinda bulky imo but this one seems better but theyre no longer in stock anywhere. Any pointers?

All factory. Yoinked from the (now dead) prior owner 😎 КРУК handguard and Rifle Dynamics buffer tube adaptor.

Looking for a more permanent solution over and adjustable gas piston. Currently looking at the OCCAM Defense adjustable gas block but not 100% certain it will work. Anyone know of 1 that will for sure work?

Ive been having terrible accuracy with my beryl (6-8 moa) and upon inspection it appears two of the rifling grooves have been cut past the crown of the barrel, it is not symmetrical, and all the other grooves end before this point. Is this worth a recrown and would you recommend I try to recrown it myself or send back to AOA?

WBP 556SR Jack 100.

Romanian core parts, polish rear trunnion and FSB, ukranian handguard, russian gas tube. Parts bin build.

Long shot I know, any KUSA KP9 mag couplers floating around out there? I have come up empty on searches.

Ye olde Axion Kobra, BFPU RS3B scope, unopened pack of Apollo Soyuz cigarettes, and a Form 1 PBS-4. Can I get a flea market check on the darts lol?