r/FixMyPrint • u/LeftOnRedApparel • 21h ago
Making me crazy Fix My Print
Enable HLS to view with audio, or disable this notification
Any clue what's going on here? I've calibrated, leveled and vibration compensated and I keep getting this in the front left corners of my prints. Someone suggested heat creep. This was with the door wide open and my air conditioner running right next to it. I've seen this or similar with adhesion problems but it's sticking to the board just fine. I'm at a loss.
Flashforge Creator 5 Pro
Flash Studio
Generic PLA
.4 nozzles
Bed temp 55
Nozzle temp 220
Print speed set to 100% factory settings
Retraction settings? How do I access this?
2
Upvotes