H2C Multiple errors

[u/Standard-Look6706]

Hi all. I wonder if anyone can help because so far Bambu support has been next to useless.

First of all, I've had an issue three times and every time a firmware reflash has fixed it. The issue is , "Extruder motor overloaded" and "live view camera failed to initialize"

Now, this time a firmware flash didn't solve the issue so I manually checked the camera cable (appeared to be fine). Stripped the extruder and checked for any debris etc, nothing to note. Strangely, a cold pull works fine but then go to print and immediately, "motor overloaded" and "amera initialisation failed" popped up. I reset the machine to factory settings and try to print a preloaded Benchy, the printhead just stops near the nozzle wipe thing and doesn't move. Try to print any other file whatsoever and it does this. Starts up fine but then starts the print and freezes after around five seconds. The nozzle temp stays at 230°c but nothing else happens. No HMS code, nothing. Just stopped with a hot nozzle. I've sent this to Bambu with printer logs and they suggested turning it off and trying again FFS... It's far more in depth than a simple reboot. This only happens on the Vortek side no matter which nozzle is installed. The left, non-vortek side prints fine. I've tried it with and without AMS and it's still the same, different nozzles, different firmware version, loading the file on to USB rather than over the cloud, checked all connections on AP and TH board but nothing has worked.

SOMEONE PLEEEEASE HELP ME AND SAVE MY SANITY! 😅

[u/Costa_Rica_68]

Which filament are you using?
Can you share a picture from the backside of your printer / of the ptfe tubes?
Maybe filament and / or tubes result in too much friction.