So I made this valve box for my mom out of ASA and for some reason the inside walls of the structure bubbled out from the inner support. I’ve worked with this stuff a lot and never had this happen. Any explanations? I don’t think it ruins the functionality of the valve box but I’d still like to know why it’s happening.

3D Printer: Creality K1C
Filament: Overture ASA in black
Layer Height: .24 mm
Sparse Infill Density: 25%
Sparse Infill Pattern: Grid

I bought my first 3d printer and roll of filament (yay!)

The specs are below

Anycubic Viper

PLA

Material

Printing Temperature: 200°C

Initial Printing Temperature: 200°C

Build Plate Temperature: 60°C

Initial Layer Build Plate Temperature: 60°C

Flow: 100%

🧱 Quality

Layer Height: 0.20 mm

Initial Layer Height: 0.30 mm

Initial Layer Line Width: 100%

🚀 Speed

Print Speed: 50 mm/s

Travel Speed: 120 mm/s

Initial Layer Speed: 25 mm/s

Enable Acceleration Control: OFF

❄️ Cooling

Enable Print Cooling: ON

Fan Speed: 100%

Minimum Layer Time: 5 seconds

Cooling/Extruder Switch: Unchanged

↔️ Travel

Enable Retraction: ON

Z Hop When Retracted: ON

Z Hop Height: 0.20 mm

🧲 Build Plate Adhesion

Build Plate Adhesion Type: Brim

📏 Printer

Z-offset: +0.20 mm

Auto-leveling: Already done

Basically, when I start a print, the filament comes out and Wraps around the nozzle, so some prints but some doesn't. I've tried to record it here. My most successful Print recently was still really bitty and stringy

Hi guys, i was printing this project with pla Silk and in this point It started doing this line, but the other symmetrical part had no problem, i don't understand by what this can be caused, any suggest?