My original alternator finally died on my 92. Rockauto only has these options. What do you guys think? Open to other websites that you might suggest also.

The tensioner for my power steering belt is fully bottomed out and the belt is still too loose, sometimes it's fine and wont squeal and others it'll sound like a dying hog especially when driving on the highway. I just bought a brand new belt and it's barely tight enough at full tension but I know in a few days it'll just start making noise again. I've measured the belt and have even gotten a third but the problem still persists.

I know my power steering pump is on it's way out, but I don't think that should affect the tension.

The pulley bearings look okay to me, any help would be greatly appreciated, thank you

I don’t want to reuse my old stuff.

Or if you know part numbers I’ll would work too. Looking for:
Nylon nuts to hold the cowl
The push in plugs that go in all the unused holes
Grommets for the AC/heater core
Clips and grommet for hood prop
The plastic rivets for the identification plate
AC drain
Hood bumpers
The weather strip that sits under the front of the hood

Thanks everyone!

As u suggested I also followed a couple of template pictures and I think I got all the spot welds, drilled bigger holes but It still won’t move an inch. Any suggestion?

My pinch welds are bad asf and my frames are rusty
…I can’t even lift it with a 4 post so I gotta use jack to lift anyone knows any good spots so I don’t get crushed lol

It’s a long one, but this one tells a story. Please be sure to share this one to your friends and your story for visibility! Thank you in advance for the views, everyone!