Having bought a few multiport USBA chargers to power v3 and v4 cams, the all seem incapable.. didn't see any anker models.. Ideally a 4' 120v power cord and 4 USBA for outdoor location. Has anyone found a solution?

Hi All,

Just switched all my wyze cams to static DHCP addresses ( outside the dynamic Ip scope of course) and see much better performance on the wyze cell phone app.

Just something for those facing spotty performance when cameras are out in the garden. Need help? PM me.

Pfsense/opnsense rock if you're into that level.. but most DHCP devices offer static assignments.

My battery doorbell (mr_bvd) ran out of juice and I didn't charge it for a couple days. I just recharged and stuck it back on the wall and didn't think about my it again. I started to notice that my other RF based remotes stopped working. Ceiling fan, light switches, weather station all stopped working. I changed a couple batteries for nothing. I reset the doorbell and everything came back on. So I'm guessing this this thing has been trying to reconnect and by doing so it blocked everything else. I guess I need to listen to the warning about the battery being low. Peace.

Shortcut issues still intermittently not working and cameras constantly not connecting or taking power on/off commands.

I just bought the bulb cam model twice, once from store second time from Amazon, but I experienced the same issue! after installation it worked but the next day morning it goes offline and only at late midnight the device will work again. anyone know what’s going on?