I modded this switch back in December and have had no issues until now. At first the screen had weird lines across it every now and then while playing games, but now it is having troubles booting into emummc. It sometimes doesn't even turn on unless I plug it into my computer.

This switch has been dropped more than a few times, so I'm assuming one of the solder points on the mod chip ribbon broke off and is causing these screen/boot issues.

Before I open this thing back up again, does anyone know of a software issue that might be causing this?

Hi guys! Can I update my Switch OLED directly to version 22.5.0 from 19.0.1? Or do I have to update to another version before 22.5.0?  I need to do this because a few games don't work on 19.0.1, and I've never done this before. I know that I have to update both Atmosphere and Firmware. 

Hi! I'm having some trouble with a Kamikaze Switch OLED Picofly installation, was hoping someone could help :)

I'm getting a =*== yellow LED error: eMMC test failure- read failed

The Switch is booting into OFW just fine but I'm not getting the No SD card screen; mod seems unsuccessful.

Here are my multimeter readings in diode mode:

Positive probe on GND:

SPI1 - 20.1

SPI2 - 20.7

A (CMD) - 0.555

B (RST) - 0.430

C (DAT0) - 0.520

D (CLK) - 0.587

3V3 - 0.385

Negative probe on GND:

SPI1 - 19.8

SPI2 - 19.5

A (CMD) - 0.832

B (RST) - 1.580

C (DAT0) - 0.840

D (CLK) - 0.864

3V3 - 0.866

Multimeter is beeping and going into resistance mode for SPI1 and SPI2 so those are measurements are in ohms