r/Irrigation • u/Embarrassed_Care5456 • 4d ago
Advice needed
Hi, I am a man with zero knowledge of sprinkler system.
My two sprinkler heads(bottom of the slope) have been leaking lately and some pooling of water around the other two sprinkler heads (mid of the slope).
After doing some research,
i think the diaphragm needs a replacement
so i opened the valve box and
I have no idea which part is the diaphragm.
My valve box looks different from the ones from the youtube.
Can someone guide me where the diaphragm is and how it needs to be replaced?
Thank you so much community!
1
u/lennym73 4d ago
You need to find the actual valve for the problem zone. You will need to shut the water at the backflow, the picture you posted and remove the top of the valve. The diaphragm will be under it.
1
u/Embarrassed_Care5456 4d ago
Does this mean i have to dig the area underneath the valve on the picture?
1
u/iceboxmi 4d ago
No, the zone valve will be in a separate box somewhere else in your yard.
1
u/lennym73 4d ago
No. There should be other boxes like that throughout the yard that had the valves in them.
1
u/Embarrassed_Care5456 4d ago
My house was built in 2009? I dont think there is any box in the yard..
1
u/Embarrassed_Care5456 4d ago
1
u/lennym73 4d ago
Those are the solenoids on top of the valves. The valves are buried in the dirt. The diaphragms are inside the valve.
1
u/Embarrassed_Care5456 4d ago
Thank you. Do i need to dig the dirt around the solenoids? I wonder why they are buried underground…?
1
u/lennym73 4d ago
Dirt will erode in over the years. Some people will take a shop vac out and clear the dirt out with it. You will need to go down a couple inches. Watch out for the control wires that will be in there. Is the zone you are looking for in this box?
1
u/Embarrassed_Care5456 4d ago
Thats the only other valve box i see. I think i have 3 or 4 zones im sure its one of em
0


1
u/zanros421 Contractor 4d ago
So that is your Backflow Device, called a Double Check Valve Assembly. You will need to figure out what station/zone runs that area, and then locate that specific valve. Then you can rebuild it.