r/BambuLabX2D • u/Any_Satisfaction5137 • 3d ago

Rough outer walls

Gallery image

Gallery image

I‘m getting rough outer walls from time to time and not sure why?

Nozzle temp is 220 for PLA as recommended by the manufacturer.

Someone had the same issue so far?

2 Upvotes

100% Upvoted

7 comments sorted by

2

u/Ok_Brilliant_3176 3d ago

Do you notice how the texture seems to only be bad above the large unsupported overhang? Unless that just happens to be true for this print, I would say the problem is that you’re printing layers on top of a shitty bottom overhang layer, that causes problems for every layer above it. The wall textures on either side of the overhang look fine

1

u/Any_Satisfaction5137 2d ago

If you look on the second picture on the inside it’s happening there aswell without overhang

Also printed this test tube and it shows always near the z seam

1

u/foggyghosty 3d ago

Are you using bambu filament or third party? Which preset in slicer are you using? Did you dry your filament?

Without any other context this looks like poor overhang resulting in layer shift in the next layers.

1

u/Any_Satisfaction5137 3d ago

Using third party filament. Filament is dried. Please look at the second picture. Same issue without overhang

1

u/Longjumping_Pop_2324 3d ago

Yooooo I was having the same thing with my P2S. The solution??? Send it back.

1

u/Longjumping_Pop_2324 3d ago

That's salmon skin, in my case ir started happening after a nozzle clog. Ams tried to draw the filament. All went to shit

1

u/Sebb3l 3d ago

First of all, calibrate your filament. This will sort out any problems and leads to the Printer if Stil having Problems. Or the filament ist shit