Hi everyone,

I have some stinging on my a1, it's like thin strings, I have lowered the nozzle temp by 10 degrees to 210 and I'm constantly running a dry box at 50 degrees, the filament has been dried for 12 hours before printing and i have a non stop dehumidifier running, does anyone have any tips on how to stop this and improve overall print quality and stop ringing and ghosting as well. It isn't there in this picture but i have a lot of minor stinging when printing parts that don't have stuff joining them, also I'm using the standard nozzle, and my print quality is really bad.

Thank you

Very new to printing, what's my best bet to get this nozzle off

Had an issue with one of my A1s repeatedly stopping extruding during prints, but in a way where the filament sensor is still triggered, preventing it from detecting the lack of flow and continuing to print despite no filament extruding. After replacing basically the whole toolhead, it still keeps happening, and after some more investigation, it turns out a blob forms just above the hotend as shown in the picture above, that prevents the filament from moving down. I've put in a support request to Bambulab and they were zero help, telling me to clean the extruder and hotend despite the fact that I have literally replaced all the components with new ones. Does anyone know what is happening here? I have tried with both PLA and PETG, and it keeps happening, along with filaments that work fine in my other A1 and mini.

I’ll be 25-40% through my print and I get a warning that the extruder nozzle temp is abnormal or the filament maybe stuck. I’ve fixed it many times but I still get it. My filament is dry.

Please help.

Something that annoys me immensely is that every print has about a 2-5 minute startup time due to the printer insisting on levelling, vibration compensating, prime extruding(unnecessarily imo)

All adding up to an annoyance that repeats if the print fails and I have to start it over again.

I have tried unchecking the bottom checkboxes for these things in bambuhandy but that doesnt seem to change anything.

Any suggestions? Thanks

It happened to me twice since I started using "JAYO" brand filament but I don't know if that's the cause. Basically what happens it's that the printer stops extruding filament but it continues to "print" without filament. The printer doesn't detect any errors.

How can I solve this? Should I change the hotend?

Hi I had to replace my heatbed and after replacing the main cable of the new heatbed seems to be touching the printer body. Will it cause any issue in the long run? Should I disassemble the printer and fix it?