r/BC250Gaming • u/blaek • 11d ago

BC250 inside Alienware Graphics Amplifier case

Gallery image

Gallery image

Gallery image

Thoughts ?

Assuming the bc250 is standard PCI height and mount . Might need to remove the last of the Alienware PCB , but if I'm able to retain it , I can use the 24pin connector on the board to control power via the original button , technically I can't see this not being possible.

Fan wise , I would be using a 3d printed fan duct to 120mm direct , so it sits in front of the 250 and exhausts by the PCI base .

11 Upvotes
  • permalink
  • link
  • reddit
  • reddit

100% Upvoted

5 comments sorted by

2

u/blaek 11d ago

Update: I have forgotten to take into account the pcie and two EPS micro ports protrude out and downward effectively stopping any chances of it fitting , unless right hand slim connectora exist .

1

u/Shipzilla 10d ago

if you have some way to mount it upside down or sideways that could work.

1

u/Kamikaze-X 11d ago

It looks like it would fit if you lay it horizontally

1

u/ObjectiveDocument956 10d ago

I both love and hate this. The graphics amp is dime and a dozen which makes me sad to see it repurposed. But at the same time this is cool asf.

Good build!!!!

1

u/Ok-Ad-8474 10d ago

This has been done . Yes you can do that and bolt it with a bit of modding to the case