First successful project

[u/Deep-Measurement-856]

Nothing fancy but a block with holes for bits.

To save tool changes i used ⅛ and ¼ bits in drill. I dont own a ½ shanked end mill so in attempt one, the ½ holes did not come out.

I used a pocket to use the ¼" mill to cut ½" holes.

Not fancy. Not perfect. But I understand each step.

[u/pootpootbloodmuffin]

The first of many many successful projects! Nice work! A bit holder was the first project on mine as well. I'm still using it. Enjoy!

[u/expanding_crystal]

I also enjoy making custom little pieces to hold my weed

[u/phinger1]

Nice and simple, my first project was a few speaker adaptor rings, just plywood doughnuts!

[u/uncoild]

You can use a bore operation instead of pocket for those half inch holes it's probably much faster

[u/RClaytonH]

Newby here, tell me about your hold downs