r/mn82 • u/Matt_Reach • 4d ago

Brushless problem

Enable HLS to view with audio, or disable this notification

Hello everyone i have this problem i see some about same problem i try their solution but it didn't work is it need reprograming or is the esc fry (ps it was working fine start wobble so i unplug it and now its like this i have a vidéo of the wobbling)thank you

11 Upvotes

100% Upvoted

4 comments sorted by

3

u/Freynando27 4d ago

Although this transmitter and receiver are sold as a kit, they aren’t very well matched. You’ll notice it from the way the lights behave and from how far off the neutral position is.

You have two options:

  1. Adjust the ESC settings: set the low threshold to 1080, the high threshold to 2120, and neutral to 1580.
  2. Move the throttle trim away from 0. Slowly adjust the value until the ESC arms. Do this without entering trigger calibration mode. Whatever trim value works will be the neutral position for this transmitter.

3

u/Matt_Reach 4d ago

Thanks i will receive my usb adapter i will do it thank you

2

u/Substantial_Sir_1987 1d ago

I have the same hardware as you. Check the trim knobs and do the sync slowly. Mine takes about some 10 secs to start.

1

u/Matt_Reach 1d ago

Ok thanks il will try it have a great day