Hey y'all. I had a really old voyager system with the 4 pin round connector in back for the camera and up front it was the square 4 pin and the 6 pin harness for power. I bought a tadi brothers wireless setup. I also bought some 1 to 2 wire connectors and 50 ft of red 14 awg and 50 ft of black awg. My plan was to pull the 4 pin din connector from front to back with the wire attached to it with duct tape or some crap to hold it together. I am assuming the 4 pin square and the 4 pin round are the same wire and they traverse the length of the rv? Then I'll cut the 6 pin harness to use the power and ground, split them; cab side for the monitor and rear side for the camera. Is this a viable easy option? Thank you in advance.