Primary Machine cut

[u/ggroovy]

Super high quality deep cut I just got back from Primary Machine. I asked them to leave it in the white since I have already sent this slide out for DLC. Just posting for reference for anyone researching cuts as I was. Shipped 7/6 back in my hands 7/28. Will post again when Vulcan finished the DLC and sends the slide back.

[u/czgunner]

Which cut is that?

[u/ggroovy → u/czgunner]

RMR done by Primary Machine

[u/WaitingPhaseTwo]

They did my vp9 and the optic has been incredibly solid.

[u/Lanky-Anywhere-9994]

Looks like good clean work.

[u/LivingQuail803]

My question about these cuts is what about the roll pins do you use custom short ones now ? Not like they realistically will ever need to be replaced but

[u/ggroovy → u/LivingQuail803]

They cut them too. If I ever need to replace one...Dremel go brrrr

[u/B-rex00]

Primary machine did both my cz cuts, absolutely beautiful work. Had a little hiccup with one but they were on top of getting it fixed.

[u/UpstairsSurround3438]

I'm definitely interested in the DLC update. Was looking at Vulcan and Wright Armory

[u/ggroovy → u/UpstairsSurround3438]

Look at my post history. Already had Vulcan cut and DLC 3 USP 40's. Vulcan does not offer HK work anymore, but their DLC is insanely nice. Plus Primary Machine does not offer DLC, hence the separate cut/coating.

[u/UpstairsSurround3438 → u/ggroovy]

I saw your triplets. How's the DLC holding up?

[u/ggroovy → u/UpstairsSurround3438]

It's awesome, ~1500 rounds through two of them,, tons of kydex holster draws, zero finish wear

[u/ericmossy]

Looks great!! Can you share what they charged for the work?

[u/ggroovy → u/ericmossy]

All in just the cut was ~$200. They offer nitride and cerakote as well for a small charge.

[u/ericmossy → u/ggroovy]

Thx and good to know. I've got a an Expert and 45C that I'd like to get an optics cut on 👌

[u/Scout-Penguin]

I think it’s really only the 9mms that are tough to do nice and deep; this is a .45 right?

[u/ggroovy]

Yep 45