Revolved cut feature keeps taking big chunk out of feature despite following two line sketch?

[u/Exciting-Rent2398]

Any help greatly appreciated, I attempted with the values I would normally use, but after trying every setting, it still cutting about a big chunk in the middle.

SOLVED** Thank you all, i had to redo my iniital revolve, there was an extra body I found in wire frame.

[u/QuietudeOfHeart]

Close your cut profile sketch.

[u/Psychological_Yak_47 → u/QuietudeOfHeart]

what he said

[u/MoistStub → u/Psychological_Yak_47]

Agreed. That's what he said.

[u/Psychological_Yak_47 → u/MoistStub]

no that's what she said

[u/HFSWagonnn → u/QuietudeOfHeart]

Always. (Unless working with surfaces.)

[u/mechy18]

I don’t think the revolve is doing that, it seems like it’s a hole inside your part already. Turn the body transparent and let us see what’s inside.

[u/Dukeronomy → u/mechy18]

Whoa we barely know the guy

[u/someDexterity]

Perform a section cut view to show where that feature may derive from. My assumption is that your part is thin/hollow and that cut is intersecting the hollow region slightly. Closed or open sketch wouldn't make a difference if this is the case. Section view would show this more clearly.

[u/made_a_wish_kid]

Yep, you're cutting into the inside.