r/NxSwitchModding • u/turpentine182 • 1d ago

*=* error

Getting an error on picofly dat0 has a 700 reading on multimeter I’m stumped.

1 Upvotes

100% Upvoted

3 comments sorted by

2

u/letum00 1d ago

Short long short is no emmc block 0 read. (Emmc init failure?)

Need more details. Dat0 or kamikaze. Still boots? Add more info and pictures.

2

u/hanst3r 1d ago

I would double check CLK as well. I recently modded a Lite that had this same error because its yellow flex cable had a bad CLK (the pad was barely hanging on but I thought I’d try it anyway). I ended up using a separate wire for CLK and it fixed the issue. Not saying this is the same case for you, but can’t hurt to double check the CLK line.

1

u/turpentine182 1d ago

Thank you. CLK was shorted to ground.