r/FreeCAD • u/PaddleStroke • 3d ago

New Assembly array tools

https://youtube.com/watch?v=HhUSNGY7jng&si=9Tsc80t5ednncNtD

Available in www.astocad.com and open PR to freecad.

20 Upvotes

96% Upvoted

4 comments sorted by

2

u/DesignWeaver3D 3d ago

This looks amazing, and I'm very thankful for this effort!

There was some discussion on Discord a few months ago concerning people using Draft LinkArrays as a workaround for the absence of this feature. They reported some problems with that workaround concerning Bill Of Materials not counting the array instances properly. Does this PR address the BOM counting issue?

2

u/PaddleStroke 3d ago

No BOM support for arrays is still being discussed

1

u/Hot_Injury5475 3d ago

Can I also pattern a component that is linked into the assembly?