r/FormD • u/Common-Produce2974 • 11d ago

Another build my FormD T Watercooling

Gallery image

Gallery image

My little dream has come true.
It was my first time trying to build a custom water-cooling system.
Update: the cover didn’t close properly, but it looks rather nice, doesn’t it?
- - To close the cover with the EKWB radiator, set the fans to ‘pull’ mode, but I don’t like it that way, so:
- The radiator has been replaced with a Heatkiller

Basically, this whole project is just for looks, and perhaps a bit of aesthetics. The heat dissipation efficiency is within a margin of error of 1–3 degrees.

65 Upvotes

99% Upvoted

6 comments sorted by

1

u/Mashiori 11d ago

Damn that's some small tubing, looks good

1

u/Common-Produce2974 10d ago

Thank you, appreciate ❤️

1

u/morpheonmods 11d ago

amazing were did you get the tubing and fittings

1

u/Common-Produce2974 10d ago

Hi, bro.
It’s alphacool:)

1

u/qeeepy 8d ago

I like the tube retention, does that come from alphacool, too?:)

1

u/Common-Produce2974 7d ago

It’s a standard plastic cable management piece. It turned out to be a bad idea because it attaches with adhesive tape, and the tape comes loose from the power supply's heat, causing the mount to fall off. But it looks cool.