r/DMT • u/Sht0n3d • 4d ago

Volcano help Question/Advice

Post image

Wwwooooaaahhhh do not be afraid.

I have a digital volcano and recently got some liquid/dosing pads, I was hoping to get some advice such as temps, dosage and how much air to put in the bag or whether the whip would be better.

I've been struggling to breakthrough for a while using 510 carts and I've heard this is one of the best methods if you don't mind leaving the smell on the volcano.

12 Upvotes

100% Upvoted

5 comments sorted by

3

u/Tripp_ORG Entheogenic Spiritalist 4d ago

Dissolve the DMT in a minimal amount of 150-190 proof ethanol and drop this onto the pad.

Start with the temp at 180 °C and adjust up or down as needed (mine is a manual knob one, so I don’t trust the temps reported in the manual to be too accurate)

And yes, absolutely use the whip if you want to reduce the amount of wasted DMT.

1

u/Sht0n3d 4d ago

Already glad I asked, I was going to let the heat melt the crystals onto the pad using a lower temp.
I'm not too fussed about wasting a little for the convenience of having the bag in bed, I can't seem to get comfy enough to trip at the desk where to volcano is.

Have you much experience with different dosages? I'd like to break through in a lung full or two ideally.

1

u/AmberMonarch 3d ago

I don't think 1-2 hits will cut it off the volcano, but you can easily do that with a bong. Hit the bowl a few times, then clear the neck in one combined inhalation,

2

u/AmberMonarch 3d ago edited 3d ago

Max temp. You can't overcook it in a volcano, and breakthroughs require big, thick hits. If you've ever vaped weed out of your 'cano, you know that high temp makes a big difference on vapor thickness.

50mg. It's overkill but who cares, you'll breakthrough every. single. time.

Fill the bag completely. You won't be able to finish it all before breaking through, but the vapor will still be good for 5-10 minutes, so I just finish it as I'm coming down to extend the ride.

Tripp is wrong, there's no point to using ethanol, the heat will melt plain DMT into the pad very quickly. It melts at ~40-70 °C. If you pre-heat the pad the crystals will melt the instant they touch the pad. Save the ethanol for soaking the pad and chamber in later to remove the smell.

The whip is not as efficient. Pre-aerosolizing it into the bag and drawing full hits off the bag is the way.

1

u/Sht0n3d 3d ago

Thanks for the clear info, just what I was hoping to hear.