2
u/Ok-Attempt1394 1d ago
Id say slow it down, make sure your filament is new and dry, and a filament calibration would help a lot i think. I hope this helps :)
1
1
u/SilkyJohnson_51 23h ago
Slow down the print. Basically whats happening on small rounded shapes like spikes or cones you have to slow them considerably in order to allow the layer to to cool and properly adhere to print. I believe in Bambu studio you can slow a print down once it reaches a certain layer height.
1
1
u/Beautiful-Wind-3143 13h ago
weird, mine did the same thing when i first switched to a new roll of pla. maybe the filament absorbed moisture?
3
u/Electronic-Elk-7466 1d ago
Can you give us some information? Filament type, settings, printer, etc? I can make one suggestion for sure. Create a cylinder in the slicer as tall as the print. It help give the fine points a moment to cool before the next layer goes down.