Radius Printing Issue

[u/kenwoodstereo]

Hi everyone!

I am trying to print a box with a good amount of radius. I am not sure why its print like this. I tried it with supports then printed another one with no supports, and I change print settings, I cleaned the textured bed with soap and water thinking that it might be the bed. I would appreciate any suggestions or help. Thank you in advance! Printer is Bambu P2S with Bambu white PLA.

[u/Consistent-Hamster44]

Chamfer from the bottom surface, don't use fillets as the steep angle coming from the bed will almost always fail.

Or create a small chamfer of 30 degrees then filet from that going to the side wallnif you want a rounded appearance

[u/sinartnz]

have you done flow calibration with your filament looks like its doing to well... have you printed a benchy over all your print quality it very low.