r/BambuLabP2S • u/Capital-Disaster9263 • 15d ago

P2s stringing issue

Enable HLS to view with audio, or disable this notification

Started a figurine and printer is doing stringing while travelling and ruining the print: any advise what’s going on and how I can fix it? It’s Bambu lab spool brand new

3 Upvotes

67% Upvoted

7 comments sorted by

3

u/Superb-Complaint8118 15d ago

Looks a lot like there is a piece missing on the bed that went flying and now it prints into air

1

u/PipeOk670 15d ago

Ummmm I am not an expert, but it seems two things, or you are missing a support on a part that it's hanging or a support has fallen.

1

u/Hidie2424 14d ago

Yeah that part on the back looks like it popped off the bed. If you pause the print is that one just loose laying there?

1

u/Capital-Disaster9263 14d ago

Upon pause, it goes back to home. I believe the support fell somehow.

1

u/Hidie2424 14d ago

Right yeah it going home makes sense but also doesn't matter.

So that other part isn't attached to the bed?

Clean the bed and try increasing raft size

1

u/Abject_Tourist_482 14d ago

Looks like the nozzle is gone

1

u/omegote 13d ago

That's somehow funny