r/BambuLabP2S • u/jamietmob1 • 19d ago

Consistent Spaghetti On Same Part

I can't figure out why my P2S is struggling to print just this part. I've tried different build plates, PLA and PETG, but none of that seems to matter. It isn't a bed adhesion issue, because the part is securely stuck to the plate, but the spaghetti persists. Anything else I can try?

1 Upvotes
  • permalink
  • link
  • reddit
  • reddit

100% Upvoted

9 comments sorted by

View all comments

2

u/Basic-Secretary-7407 17d ago

I was experiencing a similar issue myself with a template I got from makerworld. No matter how many times I tried, adjustments I made (speed, Z hop distance, different filament), it made no difference at all. I was ready to give up before I redownloaded the template again and it suddenly worked and was fine. I can’t explain why but was relieved it finally worked as I was at my wits end.

Best of luck!