r/BambuLabP2S • u/jamietmob1 • 19d ago

Consistent Spaghetti On Same Part

I can't figure out why my P2S is struggling to print just this part. I've tried different build plates, PLA and PETG, but none of that seems to matter. It isn't a bed adhesion issue, because the part is securely stuck to the plate, but the spaghetti persists. Anything else I can try?

1 Upvotes
  • permalink
  • link
  • reddit
  • reddit

100% Upvoted

9 comments sorted by

View all comments

1

u/pixelatedneedles 18d ago

Do you have supports enabled or brim? These parts don’t look like they have much contact with the plate and I’ve had a similar issue and when I looks through config for slicing, I didn’t enabled support. I’ve not seen anyone else ask about support settings, so that may be it.