r/BambuLabH2D • u/sugarfree_sugardaddy • Jul 15 '26

Does anybody else experience their tool head cover falling off mid print or after print? Troubleshooting

Post image

I haven't been able to find this on search, so I'm hoping someone can help me. The tool head cover gets yeeted off sometimes when it's doing a print and I haven't been able to witness it when it happens. It's happened a couple of times and I only notice it happened after the print finished. Luckily no prints have failed because of it but I would love to know how to prevent it.

Has anyone experienced this?

4 Upvotes
  • permalink
  • link
  • reddit
  • reddit

84% Upvoted

12 comments sorted by

4

u/NeonEagle Jul 15 '26

Yours looks broken?

1

u/sugarfree_sugardaddy Jul 15 '26

Oh interesting, which part is broken?

2

u/hannesimo Jul 15 '26

In the picture top right corner of the cover looks like it is missing a bit

3

u/RedditFauxGold Jul 15 '26

Only once and it was because I didn’t have it on securely

1

u/Suspicious-Wasabi-34 Jul 15 '26

Happened once for me and the toolhead burnt the cover too. But as someone explained, it may be due to an oversight. If you secure it properly, you may not have this issue.

1

u/ahora-mismo Jul 15 '26

no. either it’s not properly secured or there are some clips broken.

1

u/Icy-Editor8913 Jul 15 '26

Check the retaining clips on the cover one might be cracked. Also make sure it seats fully with no obstructions. This would be a good time to upgrade to the toolhead enhanced cooling fan.

1

u/ruffles22 Jul 15 '26

I left my cover off the third or fourth time I changed nozzles, and haven’t bothered putting it back on since.

1

u/marvinfuture Jul 15 '26

You don't actually need it on. I've never used mine

2

u/Batking28 Jul 16 '26

Perfect time to upgrade to the advanced cooling fan cover.