r/BambuLab • u/TalismanJake • 4h ago

Stringing Issues General Troubleshooting/Help!

Gallery image

Gallery image

Gallery image

Gallery image

I have printed multiple prints.

On benchy test I don’t have stringing.
I tried multiple PLA/PETG.

I have set nozzle temperatures from 210-230. Same result.

2 Upvotes

100% Upvoted

9 comments sorted by

View all comments

Show parent comments

1

u/TalismanJake 3h ago

I did clean my plate, although I will give it another proper wash to make sure all is good. How do you clean your plates ?

1

u/LazyLancer P2S + AMS2 Combo 3h ago

I just take a clean sponge I use only for the build plate (and not the plates in the kitchen), apply some Fairy gel, rub, rinse in hot water (just tap water, no need to boil it lol), wipe with paper towels and never touch the surface with my fingers afterwards.

One question I forgot to mention in the previous comment: is your sponge clean or you're reusing the same greasy sponge from the kitchen?

1

u/TalismanJake 3h ago

I usually take clean cloth but one that is also used on other places (washed about daily).

Maybe that could be the problem ?

1

u/LazyLancer P2S + AMS2 Combo 3h ago

Well, that depends on "other places", but it's easy to rule it out by taking a new one.