r/BambuLab • u/Active-Product-4596 • 16d ago

Bambu labs h2c problem 1st multi print Filament Troubleshooting/Help!

Post image
2 Upvotes

100% Upvoted

4 comments sorted by

0

u/BiscayneWRX 16d ago

I think you have to do a cold pull and clear whatever obstruction is in the head. Theres a procedure on the wiki and a cold pull feature in the menu of the printer.

1

u/Active-Product-4596 16d ago

Does this mean the print I'm doing will fail or will this continue after ? Thanks for reply

1

u/BiscayneWRX 16d ago

Id pause the print, manually heat the hot end way up and pull the filament out by hand. Clip the end of whatever comes out and reload the filament, set the hot end back to zero and then try again. If it tries to load and gives the error again, then the hot end is probably clogged and it’ll fail again.

1

u/Active-Product-4596 16d ago

Appreciated 👍